AQA GCSE Combined Science: Trilogy (8464) · Spec Required practicals Physics Paper 1
Required practicals, Physics Paper 1
Read the notes, then try the questions. Each one is marked the moment you press Check, and shows the right answer and why.
Key ideas
- Specific heat capacity: use the formula ΔE = m × c × Δθ with an electrical heater and a thermometer. Insulate the block to reduce heat loss.
- Resistance: measure current and potential difference for different lengths of wire, with the ammeter in series and the voltmeter in parallel.
- I-V characteristics: plot current against potential difference for a resistor, a filament lamp and a diode. Only the resistor gives a straight line through the origin.
- Density: find the mass on a balance and the volume by measurement (regular solid) or by displacement (irregular solid), then use density = mass ÷ volume.
Key terms
- Independent variable
- The variable you change in an investigation.
- Dependent variable
- The variable you measure.
- Control variable
- A variable you keep the same to make it a fair test.
- Repeatable
- You get the same result if you repeat the investigation with the same method and equipment.
Common mistakes
- Describing what to do without saying what is measured and what is kept the same. Every method needs the variables.
- Calling a result accurate when it is repeatable. Accuracy is closeness to the true value; repeatable means you get the same result again.
Exam tip
In a method answer give the apparatus, what you change, what you measure, what you keep the same, and how many times you repeat it.
Free practice questions
7 questions, 15 marks. Answer, then press Check. The marking guide explains how the marks are worked out. Nothing is saved.
- Question 1 · Multiple choice[1 mark]
A student measures mass in g and volume in cm³. Which unit does the calculated density have?
- Question 2 · True or false[1 mark]
True or false: A diode lets current flow in one direction only.
- Question 3 · Fill the gaps[1 mark]
Resistance is found by dividing potential difference by ___.
Word bank: current · power · charge · length
- Question 4 · Matching[3 marks]
Draw one line from each quantity to its type of variable in the practical.
- Question 5 · Put in order[3 marks]
Put the steps for finding the density of a regular metal block in the correct order. Mateo finds the mass of the block before its volume.
Use the arrows to put these in the right order, first at the top.
- 1Set the balance to zero
- 2Place the block on the balance and record its mass
- 3Divide the mass by the volume to find the density
- 4Measure the length, width and height of the block with a ruler
- 5Multiply the three lengths to find the volume
- Question 6 · Sort into groups[5 marks]
Complete the sorting task: put each statement under the component it describes.
The I-V graph is a straight line through the origin
The I-V graph is a curve that becomes less steep
Current flows in one direction only
The resistance increases as the filament gets hotter
The resistance stays constant while the temperature is constant
- Question 7 · Multiple choice[1 mark]
Which meter is connected in parallel with the wire to measure the potential difference across it?